Minolta Di152 - Turning ON and OFF and the Initial Mode

FrameMaker Ver.5.5E(PC) DIS/REASSEMBLY, ADJUSTMENT FOR Di152/Di183
01.09.03
D-27
(9) Winding of the Scanner Drive Cables
1. Wind the cable around the rear cable pulley of the pulley assy from side B toward side A
and then secure the cable with tape.
2. Wind the cable around the front cable pulley of the pulley assy from side A toward side
B and then secure the cable with tape.
NOTE
• Make sure that no part of the cable rides on the other.
Rear
Front
4022D003AA
Bead Position
Rear
Front
Bead Position
Winding
Direction on Side B
A
B
➀➁➂➃
Winding Direction
on Side A
➀
➁
➂
➃
➀➁➂➃
A
B
Winding Direction on Side B
Winding
Direction on
Side A
➃
➂
➁
➀
3. Secure the pulley to the rear cable pulley using
two screws.
NOTE
• Make sure that the pulley is doweled to the cable
pulley.
4022D005AA