7
Using the Utility Mode
7-30 Di152/Di183
7.7 Storing a Job
You can store frequently used job settings in memory to call up later for
quick job setup. Up to two different settings can be stored: job 1 (Jb1) and
job 2 (Jb2).
✎
Note
No jobs can be stored while the copier is warming up or is in the
Interrupt mode.
Job Storing Procedure
1
Set up the job you want to store in memory.
2
Press the [Job Input] key.
3
Check that “Jb1” appears on the
Display.
If you want your job stored as “Jb2,”
show it on the Display.
?
Do you know how to change the
contents of the Display?
➜
Each time the [Job Input] key is
pressed, the Display alternates between “Jb1” and “Jb2.”
?
Do you know what happens if another job has already been stored
in the job number selected?
➜
Storing a new job will erase the old one.
To Next Page
Loading...
