Minolta DYNAX 404SI MAXXUM STSI User Manual

15
LENS
14
LENS
1. Remove the body and rear
lens caps.
2. Align the red mounting dots
on the lens and camera body.
3. Gently insert the lens into the
mount, then turn it clockwise
until it clicks into the locked
position.
• Do not insert the lens at an angle.
• Do not press the lens release when
attaching the lens.
Attaching the Lens
1. Press the lens release and
turn the lens counter-
clockwise until it stops.
2. Gently remove the lens and
replace caps, or attach
another lens.
Removing the Lens
Caution
• Do not force the lens if it does not turn smoothly.
• Do not touch the inside of the camera, especially the lens
contacts and mirror.

Minolta DYNAX 404SI MAXXUM STSI Specifications

General

Film Format	35mm
Focus	Autofocus
Lens Mount	Minolta A mount
Flash	Built-in
Exposure Control	Manual
Power Source	2x CR2
Camera Type	SLR
ISO Range	25 - 5000