FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 DIS/REASSEMBLY, ADJUSTMENT
98.04.13
D-4
Purpose of Application of Red Paint
Red paint is applied to the screws which cannot be readjusted, set, or reinstalled in he field.
The basic rule is not to remove or loosen the screws to which red paint is applied. In addi-
tion, be advised that, if two or more screws are designated as those which must not be
touched on a single part, only one representative screw may be marked with red paint.
Do not turn the variable resistors on boards for which no adjusting instructions are given in
“ADJUSTMENT.”
1-3. PARTS WHICH MUST NOT BE TOUCHED
(1) Screws
(2) Variable Resistors on Board
(3) Other Screws
Lower Pre-Image Transfer
Guide Plate (2 screws)
1139D078AA
Lens Rail height
setting screws (2)
To Next Page
Loading...
