Minolta MN40WP - Securing the Battery Door; Battery Charging Procedure; Powering the Camera On and Off; Switching Between Camera Modes

)LUVW8VH

2.4 To Lock the Battery Door
1. Press the battery door down firmly until it is completely flat.
2. While the battery door is pressed down, slide the door latch into the locked
position as shown in the figure below. Use a fingernail or other pointy object
when sliding the latch to get a better grip. The battery door is fully locked
once the latch clicks into place.
2.5 Charging the Battery
Connect your camera to the included AC adaptor with the USB cable
provided for charging. Insert the small end of the USB plug into the camera’s
port under the battery door, and the larger end in to the included AC adaptor.
While charging the LED indicator light will light up solid red, when finished
charging the light will turn off.
2.6 Powering the Camera On/Off
Hold the POWER button for 3 seconds to power the camera on. To power
the camera off, press and hold the POWER button for a further 3 seconds.
If the camera’s battery is low, a “Low Power” message will display on the
screen and it will automatically shut down within a few seconds to prevent
memory corruption or loss.
2.7 Switching Modes
Press the MODE button to cycle between Photo, Video and Playback
Modes. The corresponding mode will be displayed in the top left corner of