14
2.11.3 Video LED Light
The video LED Light gives you the ability to capture photos and videos in a
dark environment.
To operate the video LED light, simply slide the power switch on the light to
the On position, to turn it off, simply slide the power switch to the Off position.
To charge the video LED light, insert the small end of the USB plug into the
light The LED
charging indicator light will light up red while charging and will turn off when
charging is complete.
The video LED light can be attached in a number of locations, it can be
attached directly to the camcorder in the hot shoe mount, or it can be attached
to any of the three mounting ports on the handheld stabilizer. Follow the steps
below to attach the video LED light to the camcorder.
1.
Slide the video LED light mounting tab into the mounting position on either
the camcorder or the handheld stabilizer.
2.
Rotate the locking screw on the video LED light, located right above the
mounting tab, clockwise until tight. Make sure not to overtighten the screw
as this may result in damage.
3.
To remove the video LED light, rotate the locking screw counter clockwise
until loose, then slide the video LED light out of the mounting position
where it is attached.
2.11.4 Stereo Microphone
The stereo microphone gives you the ability to capture better sound quality
than through the camcorder. The microphone includes a foam wind-guard that
helps block the sound of the wind.
To operate the stereo microphone, simply slide the power switch on the
microphone to the Low position for low sensitivity, or to the High position for
high sensitivity, to turn it off, simply slide the power switch to the Off position.
To charge the video Insert the small end of the USB plug into the
microphone o the included AC adaptor. The LED
To Next Page
Loading...
