20 21
USING THE BUILT-IN FLASHREWINDING THE FILM
The film will rewind automatically after the last
frame has been exposed.
When appears and blinks, open the
back cover and remove the film.
MANUAL REWIND
To begin rewind before the end of the
roll, turn the camera on and press the
manual-rewind button using a pen.
When you turn the camera on, the built in flash is automatically set to
autoflash or autoflash with red-eye reduction, whichever was used last. In
these modes, the flash will fire automatically in low-light and back-lit
situations.
FLASH RANGE
The range of the built-in flash depends
on the film speed and focal length you
are using. To ensure proper exposure,
make sure your subject is positioned
within the flash range.
If rewind stops before the film has been completely rewound, all the
indicators will blink. DO NOT OPEN THE BACK COVER. Insert a fresh
battery, then press the manual-rewind button.
Continued on next page.
39mm
125mm
0.6 - 7.0m
2.0 - 23.0 ft.
0.6 - 14.0m
2.0 - 46.0 ft.
0.6 - 4.5m
2.0 - 14.8 ft.
0.6 - 2.25m
2.0 - 7.4 ft.
ISO 100 ISO 400
9222-2446-11 MM A804 3/4/98 1:06 PM Page 20
To Next Page
Loading...
