What to do if AC normal icon is on but there is no output from Minuteman UPS?
If the AC normal icon is lit but there's no output from your Minuteman UPS, disconnect the computer cable from the UPS and press the On button. If the UPS then works normally, the software is controlling the UPS.
What to do if Minuteman UPS displays Er28 Bypass mode Overload?
If your Minuteman UPS displays 'Er28' indicating Bypass mode Overload, check the specifications and remove part of the load. If the error persists, call for service.
What to do if the Weak/Bad Battery icon is illuminated on Minuteman UPS?
If the Weak/Bad Battery icon is lit on your Minuteman UPS, first check the battery connections. Then, charge the batteries for 8 hours and retest. If the problem persists, the batteries may need to be replaced.
What to do if Minuteman UPS shows Er10 Inverter Over Current?
If your Minuteman UPS displays 'Er10' indicating Inverter Over Current, check the specifications and remove part of the load.
What to do if Minuteman UPS displays Er39 Low Battery Capacity?
If your Minuteman UPS shows 'Er39' indicating Low Battery Capacity, charge the batteries for 24 hours. If the error persists, call for service.
What does Er17 Low Battery Warning mean on Minuteman UPS?
The Er17 error on your Minuteman UPS indicates a Low Battery Warning. This condition will continue until AC power returns or the UPS shuts down from battery exhaustion.
What causes Er03 UPS Over Temperature on Minuteman UPS?
The Er03 error on your Minuteman UPS indicates that the internal temperature has exceeded the safe operating range. Check the UPS specifications.
What to do if Minuteman UPS displays Er13 Fan Failure?
If your Minuteman UPS displays 'Er13', it means the fan has failed or is blocked by dirt. If the fan has failed, call for service. If the fan is dirty, clean it using a can of "Canned Air".
What does it mean if the Fault icon is illuminated and there is a constant alarm on Minuteman UPS?
If the Fault icon is illuminated and a constant alarm is sounding on your Minuteman UPS, it indicates an internal problem with the UPS. Call for service.
What to do if Minuteman UPS shows Er01 and is shutdown?
If your Minuteman UPS displays 'Er01' and is shut down, it indicates a short-circuit on the output. Check the attached load to resolve this issue.
General| Type | Line-interactive |
|---|---|
| Capacity | 1000 VA / 900 W |
| Wattage | 900 W |
| Input Voltage | 120 VAC |
| Output Voltage | 120 VAC |
| Output Frequency | 60 Hz |
| Waveform | Sine wave |
| Form Factor | 2U Rackmount/Tower |
| Communication Ports | USB, Serial |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Battery Type | Sealed Lead Acid |
| Storage Temperature | 5°F to 113°F (-15°C to 45°C) |
| Humidity | 0% to 95% (non-condensing) |
| Certifications | FCC |
To Next Page