What does error code E24 mean on Minuteman UPS?
If the Minuteman UPS displays error code E24, indicating an RPO shutdown, the UPS has been remotely shutdown by either the software or SNMP card.
What to do if Minuteman UPS shows error code E15?
If the Minuteman UPS displays error code E15 and the Weak/Bad Battery icon is illuminated, check the battery connections. You may need to charge the batteries for 8 hours and retest, or replace the batteries.
What to do if Minuteman UPS shows error code E02?
If the Minuteman UPS displays error code E02, the overload icon is illuminated and a constant alarm is sounding, check the specifications and remove part of the load. If the UPS shuts down because of an Overload, the UPS must perform an Inverter function or a Self Test to clear the Overload Alarm.
What to do if AC normal icon is illuminated but there is no output from Minuteman UPS?
If the AC normal icon is illuminated on your Minuteman UPS, but there is no output, disconnect the computer cable from the UPS and press the On button. If the UPS works normally, the software has control of the UPS.
Why is my Minuteman UPS operating in battery mode when AC is present?
If your Minuteman UPS is operating in battery mode only, even when AC power is present, reset the input circuit breaker by pressing the plunger back in. If the input circuit breaker trips after UPS restarts, reduce the load on the UPS.
What does error code E22 mean on Minuteman UPS?
If the Minuteman UPS displays error code E22, indicating an Output voltage abnormal, call for service.
What does error code E20 mean on Minuteman UPS?
If the Minuteman UPS displays error code E20, indicating a DC BUS (high/low) failure, call for service.
What does error code E21 mean on Minuteman UPS?
If the Minuteman UPS displays error code E21, indicating a DC-DC converter failure, call for service.
What does error code E18 mean on Minuteman UPS?
If the Minuteman UPS displays error code E18, indicating Low Battery Capacity, charge the batteries for 24 hours.
What does error code E03 mean on Minuteman UPS?
If the Minuteman UPS displays error code E03 and shuts down, it indicates that the transformer and/or the heatsink temperature has exceeded the safe operating range for the UPS. Check the specifications.
Key safety directives to be followed during installation and maintenance.
Instructions for securing the UPS to a rack using mounting brackets.
Guidelines for selecting an appropriate location for UPS installation.
Details various functions that can be configured via software or hardware.
Steps to follow when the UPS requires service or repair.
Lists common UPS symptoms and error codes with their causes and solutions.
Step-by-step guide for safely replacing the UPS battery module.
To Next Page
General