To Next Page
H
housecynthiaSep 2, 2025
What does error code E16 on Minuteman UPS mean?
- Rralph08Sep 2, 2025
If the Minuteman UPS displays error code E16 and the SWF icon is illuminated, have a qualified electrician correct the service wiring.
What does error code E16 on Minuteman UPS mean?
If the Minuteman UPS displays error code E16 and the SWF icon is illuminated, have a qualified electrician correct the service wiring.
What does error code E13 mean on Minuteman UPS?
If the Minuteman UPS displays error code E13 and indicates a Fan Fail Warning, it could be due to fan failure or excessive dirt. If the fan has failed, call for service. If the fan is dirty, use a can of "Canned Air" to clean the fan.
How to troubleshoot Minuteman UPS not providing expected runtime?
If your Minuteman UPS is not providing the expected runtime, charge the batteries for 8 hours and retest. If the runtime is still less than expected, the batteries may need to be replaced.
What to do if Fault icon is illuminated and a constant alarm on Minuteman UPS?
If the Fault icon is illuminated and a constant alarm is sounding on your Minuteman UPS, call for service.
Why is my Minuteman UPS operating in battery mode when AC is present?
If your Minuteman UPS is operating in battery mode only, even when AC power is present, reset the input circuit breaker by pressing the plunger back in. If the input circuit breaker trips after UPS restarts, reduce the load on the UPS.
What to do if AC normal icon is illuminated but there is no output from Minuteman UPS?
If the AC normal icon is illuminated on your Minuteman UPS, but there is no output, disconnect the computer cable from the UPS and press the On button. If the UPS works normally, the software has control of the UPS.
What to do if Minuteman UPS shows error code E02?
If the Minuteman UPS displays error code E02, the overload icon is illuminated and a constant alarm is sounding, check the specifications and remove part of the load. If the UPS shuts down because of an Overload, the UPS must perform an Inverter function or a Self Test to clear the Overload Alarm.
What to do if Minuteman UPS shows error code E15?
If the Minuteman UPS displays error code E15 and the Weak/Bad Battery icon is illuminated, check the battery connections. You may need to charge the batteries for 8 hours and retest, or replace the batteries.
Key safety directives to be followed during installation and maintenance.
Instructions for securing the UPS to a rack using mounting brackets.
Guidelines for selecting an appropriate location for UPS installation.
Details various functions that can be configured via software or hardware.
Steps to follow when the UPS requires service or repair.
Lists common UPS symptoms and error codes with their causes and solutions.
Step-by-step guide for safely replacing the UPS battery module.
General
