Minuteman ER26 - Page 20

5. Table of Error Codes (SC280000 Models)
2C00
LOW BATTERY ERROR
Battery Charge to low. Recharge battery.
2C01
LOW BATTERY ERROR2
Battery Charge to low. Recharge battery.
2C02
SOFT BATTERY LOCKOUT OCCURRED
Battery Charge to low. Recharge battery.
2C03
SOFT BATTERY LOCKOUT 2 OCCURRED
Battery Charge to low. Recharge battery.
2F01
TILLER DISPLACED ERROR
Throttle displaced on Power-up. Release throttle and then re-engage throttle.
3A00
BAD SETTINGS
Illegal program parameter settings.
7000
STARTUP WITH PUSH SELECTED
Freewheel Input signal detected at startup. Disconnect Freewheel input.
7001
PUSH ACTIVATED IN DRIVE MODE
Freewheel Input signal activated while driving. Disconnect Freewheel input.
7500
TILLER COMMS TIMEOUT
Problem with LCD Module or wiring. Repair or replace as necessary.
7600
SOFT BRUSH MOTOR DISCONNECTED ERROR
Check Brush Motor wiring and connectors
7601
SOFT BRUSH CURRENT FOLDBACK
Too much Brush Pressure/Current. Check for jammed Brushes or Deck or Brush motor short.
7602
SOFT BRUSH CURRENT FOLDBACK2
Too much Brush Pressure/Current. Check for jammed Brushes or Deck or Brush motor short.
7602
SOFT BRUSH CURRENT FOLDBACK2
Too much Brush Pressure/Current. Check for jammed Brushes or Deck or Brush motor short.
7603
SOFT BRUSH CURRENT FOLDBACK3
Too much Brush Pressure/Current. Check for jammed Brushes or Deck or Brush motor short.
7604
SOFT BRUSH INHIBIT
Brush Inhibit signal is active.
7605
BRUSH STARTUP OVERCURRENT DETECTION
Possible Brush motor problem or shorted brush circuit wiring.
7700
SOFT VACUUM MOTOR DISCONNECTED ERROR
Check Vacuum Motor wiring and connectors
7701
SOFT VACUUM CURRENT FOLDBACK
Too much Vac motor current. Check for shorted Vac motor or wiring.
7702
SOFT VACUUM CURRENT FOLDBACK2
Too much Vac motor current. Check for shorted Vac motor or wiring.
7703
SOFT VACUUM CURRENT FOLDBACK3
Too much Vac motor current. Check for shorted Vac motor or wiring.
7800
TRACTION MOTOR FAULT-1
Check Traction Motor wiring and connectors
7801
TRACTION MOTOR OVER CURRENT ERROR
Too much Traction motor current. Check for shorted Traction motor or wiring.
7802
TRACTION MOTOR IN FOLDBACK STATE
Traction Motor was overloaded for too long, Control limiting current to protect motor.
7803
MOTOR LINE VOLTAGES INSTABILITY TIMEOUT
Possible Traction Motor or loose wiring problem.
7804
TRACTION MOTOR IN DRIVE BOOST
Traction Motor under heavy load or Current Limit / Fold back parameters set too low.
7880
TRACTION SPEED INPUT OUT OF RANGE
Check Throttle Potentiometer and wiring.
7900
EMERGENCY STOP ERROR
Emergency Stop function activated.
7901
SOFT BELLY BUTTON ACTIVATED
Safety Bar switch is activated. (ES and CP models only)
8000
SERVICE MODE
Service Timer limits have been reached.
9000
BRUSHES NOT FITTED
Check Brush Deck to make sure Brushes are fitted properly.
Page 20