13
12
RACKMOUNT CONFIGURATION
This UPS series comes with mounting brackets for the standard 19" (46.5cm)
rack pre-installed on the UPS. The mounting brackets to fit a 23" (59.2cm)
rack and Rail Kits for 4-post racks and cabinets are also available. The
screws for mounting the UPS to the rack are included. NOTE: The mounting
brackets can be mounted in the middle of the UPS.
CAUTION! DO NOT USE THE MOUNTING BRACKETS TO LIFT THE
UPS. The mounting brackets are ONLY for securing the UPS to the rack.
ATTENTION! N'UTILISEZ JAMAIS LES SUPPORTS DE MONTAGE POUR
SOULEVER L'ONDULEUR. Ces supports sont uniquement conçus pour
fixer l'onduleur au rack.
1. Mount the UPS into the rack and secure with the four retaining screws pro-
vided. Use two or more people when installing the UPS, the UPS is extrem-
ely heavy. Do not move the rack after the units have been installed. The
rack may become unstable due to the weight distribution.
2. The Rackmount Configuration is complete. See Connecting your Equipm-
ent.
CONNECTING THE BATTERIES
(QUALIFIED SERVICE PERSONNEL ONLY)
Please read all of the WARNINGS and CAUTIONS before attempting to con-
nect the batteries.
Use two or more people when installing the UPS, the UPS is extremely heavy.
1. Remove the UPS from the shipping box and place on a flat surface.
NOTE: No tools are required for removing or installing the battery door.
2. Grasp the battery door on the left hand side, pull it outward and then set it
aside (FIG. 1).
3. Verify proper polarity. Connect the battery connectors together. (FIG. 2).
NOTE: Some sparking may occur this is normal.
4. Re-install the battery door on the UPS.
5. Connecting the Batteries is complete. See the Rackmount Configuration.
CAUTION! DO NOT USE THE MOUNTING BRACKETS TO LIFT THE
UPS. The mounting brackets are ONLY for securing the UPS to the rack.
ATTENTION! N'UTILISEZ JAMAIS LES SUPPORTS DE MONTAGE POUR
SOULEVER L'ONDULEUR. Ces supports sont uniquement conçus pour
fixer l'onduleur au rack.
FIG. 1
FIG. 2
To Next Page
Loading...
