Mio SLICE - Firmware Updates; Resetting Mio SLICE and Pairing to a New Phone; Maintaining Your Mio SLICE

Mio SLICE User Guide 13
FIRMWAR E UPDATE S
Firmware updates provide new features and device improvements. When a new rmware is available for your Mio
SLICE, you will be notied in the Accurofit App. You will also see the option to update your rmware under Device
Settings of the app.
Try the following tips if you have trouble updating your Mio SLICE:
1. Fully charge your SLICE.
2. Keep the PAI app open and do not navigate away from the app until the rmware update is complete.
3. Keep your SLICE as close as possible to the phone until the rmware update is complete.
4. Check that your phone has a stable internet connection.
5. Ensure the PAI app is not being killed in the background by a task killer app (e.g. Greenify).
6. Force close the PAI app. Then, reopen the PAI app and restart the rmware update process.
7. New devices will need 2 updates to complete. Please keep this in mind.
RESETTING MIO SLICE AND
PAIRING TO A NEW PHONE
To connect Mio SLICE to another smartphone, a reset is required:
MAINTAINING YOUR MIO SLICE
BATTERY
Mio SLICE contains a rechargeable lithium polymer battery. Follow these instructions and guidelines to maintain
the battery lifespan.
If you do not follow these guidelines, the battery life could be shortened and there is a risk of damage to your
SLICE, risk of re, risk of electrolyte leaks and chemical burns, and risk of injury.
First, clear the slice from the old phone.
-In the Accuro app, navigate to the More
section and select Remove Device.
-Close the app and open your phone's bluetooth settings. Look for the slice in your previously paired device list and remove it.
-Turn off your phone's bluetooth for now.
Next, take your slice, and place it on the charger to perform a reset.
- While on the charger, press and hold the button on the slice for about 15 seconds. the Slice will display RESET and begin counting down from 5.
Once the slice says SLICE again, you can let go of the button.
- Let the slice charge for a while, when off the charger it will display the pairing icon and is ready to be set up once agian.