Mira CODA PRO User Manual

15
OPERATION
Adjusting the Temperature
The temperature is controlled by rotating the temperature selector knob (see below).
For safety reasons, the temperature is limited by an override stop. To obtain a
higher temperature, press the override button on the temperature selector knob and
continue to rotate the knob.
Adjusting the Flow
The ow is controlled by rotating the ow selector knob (see below).
To reduce the amount of water used each time you shower, you can select the ECO
setting.
If you choose a higher ow rate, press the override button on the ow selector knob
and continue to turn the knob.
ON / Increase
Flow
Temperature
Override
Button
Temperature
Selector Knob
OFF / Decrease Flow
Flow Selector Knob
Decrease
Temperature
Increase
Temperature
Eco Setting
Flow Override Button
Eco

Mira CODA PRO Specifications

General

Enclosure Rating	IP65
Weight	300g
Measurement Range	0 - 100%
Operating Humidity	0-95% RH (non-condensing)
Output	4-20 mA