27
Packing the Main Container
Lay the secondary riser covers over the risers! Make
sure that they are tucked into the slot in the riser chan"
nel between the backpad and the reserve container!
[Fig! #]
Helpful Hint: The secondary riser covers are made of a
material that will take a shape after use! For the rig to
look its best$ ensure proper packing of these covers! A
little extra effort will insure the proper shaping of the
secondary riser covers$ which should not be visible once
the main riser covers are packed!
Fold back the main container flaps! Place the main bag
into the main pack tray! Make sure the line stows go to
the bottom of the container!
Helpful Hint: To get the best fit into the main container
insert the main bag with lines down first! Then lift up
on the centerflap with one hand to open the container
and push the top of the bag into place! [Fig %] Make
sure the bag fills the bottom corners! With the bulk
evenly distributed the main container will have a
smooth appearance!
Push the top of the bag down into place and lay the
main bridle out to the right side of the container! [Fig! &]
Thread the pull"up cord through the closing loop in the
'( flap!
Fig! #
Fig! %
Fig! &
MIRAGE SYSTEMS
To Next Page