28
Packing the Main Container
Close flap !"# being sure the main bridle is routed out
from under the right side of the !" flap$ Mate the %”
velcro on the bridle line to the %” velcro on the main
center flap$ Lay excess bridle line to the right$ [Fig$ &]
Helpful Hint: Kneel on flap !% section of pack job to
push air out and work bag into corners$ Pushing on the
bottom !% flap while pulling on the pull up cord makes
this task easier$
Close flap !'$ [Fig$ (]
Helpful Hint: Closing one side flap at a time may push
the bag and canopy out the other side$ To help with
main container symmetry# keep the main deployment
bag centered or a little to the left# inside the main pack
tray$
Close Flap !)# and insert closing pin into loop$ Check
centerline collapsible bridle window to insure that the
main pilot chute is cocked$ The centerline should show
a colored mark# not solid white$ Stow the bridle under
the right main side (!)) flap from near the closing pin
down to bottom of the container$ [Fig$ %*]
Fig$ &
Fig$ (
Fig$ %*
MIRAGE SYSTEMS
Push
Pull
To Next Page