InstaLink™ USB
The InstaLink™ USB is a bluetooth antenna that can be
connected to any computer with internet access.
USB Installation and Set-up
1
2
3
4
Connect the InstaLink™ USB
Connect the USB to a workstation that is active near where
the dosimeters are stored. It is not recommended to con-
nect to a workstation that requires users to sign in and out
after each session.
Download and Install the Software
Download the ID2Monitor application by signing into your
instadose.com account.
Click the ”download software” link and press download.*
Open the installer and follow the instructions on screen.
* Your IT Administrator may need to approve and/or enable access.
Run Software
Once the software has been installed, you will need to run it
by opening* the InstaLink™ USB Application. A dialogue box
will appear confirming that the Application is “Searching for
Instadose® devices”. If this dialogue box does not confirm
active searching, please consult the InstaLink™ USB Trou-
bleshooting Guide or contact Mirion Support.
* The InstaLink™ USB Application must be open to automatically collect
data in the background.
View Status
To view the status of connections and transfers you can
access the software in the bottom right hand tray. The icons
will indicate the communication process.
To Next Page
Loading...
