What to do if the LED on my MIRKA DEROS 325CV Sander is red and the RPM is slightly reduced?
If the LED (right) on your MIRKA Sander is red and the RPM is slightly reduced, it indicates that you're using too heavy a short-term load. Use a lighter load, and the LED (right) will automatically change to green.
How to fix no light from LED on MIRKA DEROS 325CV?
If there is no light from the LED (right) when you switch on your MIRKA Sander, the power cord is not properly attached to the sander or to the mains socket. Ensure that the power cord is properly connected.
What to do if the brake seal doesn't work on MIRKA DEROS 325CV?
If the brake seal on your MIRKA Sander isn't working, it could be due to a worn-out brake seal or a damaged spindle bearing. Check and replace the brake seal or spindle bearing if necessary.
How to fix a MIRKA DEROS 325CV Sander when the LED doesn't light up?
If the MIRKA Sander LED does not light up when switched on, the power cord may not be properly connected either to the sander or to the mains socket. Ensure that the power cord is securely connected to both.
What to do if the break seal doesn't work on MIRKA Sander?
If the brake seal on your MIRKA sander isn't working, it could be due to a worn-out brake seal or a damaged spindle bearing. Inspect both the brake seal and the spindle bearing, and replace them if necessary.
Why is my MIRKA DEROS 325CV slowing down and the LED is red?
If your MIRKA Sander's LED (right) turns red and the RPM drops to 4,000 during sanding, it indicates the temperature inside the sander is too high due to a prolonged heavy load. To resolve this, reduce the load on the sander for a while, and it will speed up again.
What to do if my MIRKA Sander stopped and the LED is red?
If your MIRKA Sander has stopped and the LED (right) is red, it means the tool has entered safety mode because of high temperature. Allow the tool to cool down before resuming use.
Why is the LED on my MIRKA DEROS 325CV flashing red and green?
If the LED (right) on your MIRKA Sander is flashing between red and green, it means that the sander is connected to a mains outlet with the wrong voltage. Connect the sander to a mains outlet that corresponds with the nominal voltage of the tool.
Why is the MIRKA DEROS 325CV LED red and the sander slowing down?
The sander LED turns red and the speed decreases to 4000 RPM due to high internal temperature caused by a prolonged, heavy load. To resolve this, reduce the load on the sander for a while, and it will return to its normal speed.
What to do if the MIRKA Sander LED is red and RPM is slightly reduced?
If the sander's LED turns red and the RPM is slightly reduced, it indicates that the sander is experiencing a short-term heavy load. Reduce the load, and the LED will automatically switch back to green.
General| Voltage | 230 V |
|---|---|
| Pad Size | 125 mm |
| Weight | 0.81 kg |
| Dust Extraction | Central vacuum ready |
| Speed | 4, 000 - 10, 000 rpm |
| Orbit Diameter | 5 mm |
| Vibration Level | 2.5 m/s² |
| Dust System | Integrated dust extraction |
To Next Page
