What to do if the MIRKA Sander stopped and the LED is red?
If your MIRKA Sander has stopped and the LED (right) is red, it means the tool has entered safety mode because of high temperature. Allow the tool to cool down before resuming use.
What to do if MIRKA DEOS 383X CV Sander LED is red and RPM is reduced?
If the MIRKA Sander LED (right) is red and the RPM is slightly reduced, it means there's too heavy a short-term load. Use a lighter load, and the LED (right) will automatically change to green.
How to fix no light from MIRKA DEOS 383X CV Sander LED when switched on?
If there is no light from the LED (right) when your MIRKA Sander is switched on, the power cord may not be properly attached to the sander or the mains socket. Ensure that the cord is correctly connected.
Why is the MIRKA Sander LED red and the sander slowing down?
If the MIRKA Sander LED (right) turns red and the sander slows down to 5,000 rpm while sanding, it indicates that the sander's temperature is too high due to a prolonged heavy load. To resolve this, reduce the load on the sander for a while, and it should speed up again.
Why is the MIRKA Sander LED flashing red and green?
If the MIRKA Sander LED (right) is flashing between red and green, it means the sander is connected to a mains outlet with the wrong voltage. Connect the sander to a mains outlet that matches the nominal voltage of the tool.
Crucial safety guidelines, required protective equipment, and general compliance statements for the tool.
Information on the manufacturer, contact details, and product certifications.
Warnings, cautions, and additional safety advice for safe tool operation.
Information regarding regulatory compliance with FCC and radio frequency rules.
Key technical specifications, noise levels, and vibration emission values for the sander.
Recommendations for the correct and intended use of the sander.
Recommendations for positioning, preparing the work area, and initial setup.
Steps for starting the tool, adjusting speed controls, and understanding operation modes.
Information on activating and using the tool's Bluetooth feature for app connectivity.
Guidance on maintenance, replacing the backing pad, and using pad savers.
Information on obtaining professional service and locating authorized service centers.
Solutions for common symptoms and operational problems encountered with the tool.
Guidelines for environmentally responsible disposal of the electric tool.
General| Model | DEOS 383X CV |
|---|---|
| Category | Sander |
| Power | 350 W |
| Voltage | 230 V |
| Pad Size | 125 mm |
| Dust Extraction | Yes |
| Packaging | Cardboard box |
| Speed | 4, 000 - 10, 000 rpm |
| Orbit Diameter | 3 mm |
To Next Page
