How to fix a MIRKA CEROS Sander with no power supply LED light?
If there is no light from the power supply LED when switched on, it could be due to: * The power cord is not properly attached to the power supply unit or the AC socket. Connect it properly. * A broken fuse. Replace the fuse; a spare fuse is included inside the fuse holder.
Why does the LED on my MIRKA Sander turn red when sanding?
If the LED on both the power supply and the MIRKA sander turns red while sanding, it indicates too heavy long-term load. To resolve this, use a lighter load, switch off the power, wait 5 seconds, and then switch it on again.
What to do if the MIRKA CEROS LED is red and the sander slows down?
If the sander LED is red and the MIRKA sander slows down to 4,000 RPM while sanding, it means the temperature is too high due to a too heavy long-term load. Reduce the load on the sander for some time, and the sander will speed up again.
What does it mean if the MIRKA Sander LED is red and RPM is slightly reduced?
If the MIRKA sander LED is red and the RPM is slightly reduced, it indicates too heavy short-term load. Use a lighter load, and the LED will automatically change to green.
How to fix no power light on my MIRKA CEROS power supply?
If there is no light from the power supply LED when switched on, it could be due to: * The power cord is not properly attached to the power supply unit or the AC socket. Re-connect the cords to solve this. * A broken fuse. Replace the fuse; a spare fuse is located inside the fuse holder.
Why is the LED on my MIRKA Sander red, and the sander slowing down to 4000 RPM?
The sander's LED turns red, and the RPM decreases because the sander's temperature is too high due to a heavy, sustained load. To resolve this, reduce the load on the sander, and it will return to its normal speed.
What to do if the LED on my MIRKA CEROS Sander and power supply turns red while sanding?
If the LED on both the power supply and the sander turns red during sanding, it indicates a prolonged, excessive load. To fix this, decrease the load, switch the power off, wait five seconds, and then switch it back on.
What to do if the LED is red and RPM is slightly reduced on my MIRKA CEROS Sander?
If the sander LED is red and the RPM is slightly reduced, it means there's too heavy a short term load. Use a lighter load, and the LED will automatically turn green.
Keep work area clean and well lit. Cluttered or dark areas invite accidents.
Power tool plugs must match the outlet. Never modify the plug in any way. Do not use adapter plugs with grounded power tools.
Stay alert, watch what you are doing and use common sense when operating a power tool.
Measured values are determined according to EN 60745.
To Next Page
General
