EasyManua.ls Logo

MirroCraft 1685 - Post-Storage Recommissioning and Trailer Prep; Interior and Trailer Storage Procedures; Recommissioning Steps After Storage

Default Icon
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26
Livewell and Baitwell:
Remove the drain tube from the livewell.
Remove as much water as possible using compressed air to blow out
water from the livewell or baitwell. You may also pour a small amount
of RV ANTIFREEZE in the drain fittings after blowing them out for
added protection.
NOTICE:
Failure to remove the water can result in burst hoses or
broken pumps.
Interior:
Clean the interior of the boat and let dry completely.
Remove all seats and cushions from boat and store in a dry place.
Clean the bilge area.
Remove all personal flotation devices and store in a clean dry place.
Trailer:
Loosen all tie downs.
Store boat on trailer with bow up to allow excess water to drain.
For further information regarding your trailer refer to the trailer
owner’s manual or contact your dealer.
Recommissioning
Inspect the fuel system for any leaks or corrosion.
Check all wiring and clean battery connections.
Charge battery and attach cables.
Reinstall drain plug.
Check livewells and baitwells for leaks.
Refer to engine manual for recommissioning the engine.
69877_36635 4/4/11 10:17 PM Page 26