22
MAINTENANCE
This section contains the various systems on your MirroCraft boat and how to
maintain it in a safe operating condition. Information can be found in the
instruction manuals that came with the systems or by contacting your local
MirroCraft dealer.
Engine: Perform engine maintenance according to manufacturer’s instructions
that came with your outboard motor.
Steering system: Inspect linkage and connections every time the boat is used.
Check manufacturer’s direction for proper lubrication and adjustments.
Electrical: Inspect battery connections, battery cables and all electrical
components after 48 hours of operation or according to the specific manual
that applies to the components in question.
Fuel system: Inspect for leaks before using the boat and inspect the entire fuel
system once a year. There are access plates in your boat to gain access to the
fuel system fittings and hoses. Contact your local MirroCraft dealer for
information about where the access plates are located in your model of boat.
DANGER:
Never operate your boat when there is fuel in
the bilge area. Contact your local dealer to have
the problem repaired promptly!
Controls: Inspect the linkage daily and adjust according to manufacturer’s
instructions.
Navigation lights: Check all lights every time you use your boat, especially when
your boat will be used after dark.
Hull and deck: Check seat hardware for tightness and check all rails and cleats.
Inspect ski pylon before use to ensure that it is installed correctly. Check for
any damage to hull every time you use your boat.
To Next Page
Loading...