18
Bilge Pump
The bilge pump is used to remove water that accumulates in the bilge area. The
switch that controls the pump is mounted on the switch panel and is protected
by a circuit breaker or fuse. Some boat models are equipped with an automatic
bilge switch. When water rises to a certain level in the bilge, the pump will turn
on automatically and when the water is pumped out, the float switch shuts off.
The bilge pump can also be turned on manually at the switch panel. To clean
your bilge pump refer to the manufacturer’s instructions that came with your
boat.
IMPORTANT: Check your bilge pump every time you use your boat and make
sure that the area around the pump and float switch is kept clean.
WARNING:
If oil or fuel is spilled in the bilge do not turn on pump.
Contact your local dealer for advice in removing the gas or oil.
Canvas
Some Canvas is installed using lift-the-dot snaps. Please see picture for proper
removal of snap.
Lift Here
To Next Page
Loading...