EasyManua.ls Logo

MirroCraft 1685 - Winterization and Storage Preparation Steps; Hull, Deck, and Livewell Winterization Procedures; Engine, Fuel System, and Battery Winterization

Default Icon
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
25
WINTERIZATION AND STORAGE
This section covers the steps in preparing your boat for cold weather or
extended storage. At this time you should do a complete inspection of your boat
and correct any problems that you may find.
Hull:
Remove any marine growth and clean according to manufacturer’s
instruction previously described in this manual.
Inspect the sides and bottom of hull for any damage.
Remove drain plug and store in a safe place.
Leave hatch door open before covering boat.
Deck:
Clean all hardware and instrumentation and check all control and
steering linkages.
Clean carpet on deck
Engine:
Check your owner’s manual for the specific instructions on winterizing
your engine or contact your local dealer.
Fuel System:
Fill the fuel tank and add a fuel stabilizer to the fuel. Follow the
manufacturer’s directions on the amount to add.
Battery:
Remove battery from your boat and charge according to the
manufacturer’s directions and then store away from freezing
temperatures.
Clean outside of battery and terminals with a solution of baking soda
and water. Do not allow the solution to enter the battery.
69877_36635 4/4/11 10:17 PM Page 25