Mistral GY4100 - Page 12

12
Operation
1. Check the safety guard and remove the blade
cover before operation (Fig.10A/10B).
2. Take a secure hold the machine and without
leing it touch the grass or brush to be cut,
press the safety lock buon and the switch
trigger(Fig.10C).
3. To switch o the machine, release the switch
trigger.
WARNING: Switch on motor only when your
hands and feet are away from the cuing
parts.
Fig.10A Fig.10A
Fig.10C
WARNING: Be extremely careful to maintain
control of the tool at this time. Do not allow the
tool to be deflected toward you or anyone in
the work vicinity. Failure to do so could result in
serious injury.
ATTACHMENT OF SHOULDER STRAP
Adjust the strap length so that the cuer blade
will be kept parallel with the ground.
Only allow single shoulder harness on the
operator.
Do not allow shoulder harness sling on the
operator.
INSTRUCTION FOR USE
Start the brush cuer or grass trimmer before
geing close to the brush or grass to be cut.
Cut the brush or grass by moving the machine
from right to left and proceed slowly, keeping
machine inclined about 30°.High grass should be
cut in layers; always beginning from the top .The
cuts should be short.
FOR GRASS TRIMMER:
Do not cut damp or wet grass. Avoid wearing the
line out quickly by knocking against hard objects
(stone, walls, fences etc) .Use the edge of the
guard in order to keep the trimmer at the right
distance.
WARNING: Do not use Excessive Force or
bash the Trimmer Bump Head on the ground to
advance the trimming line .If the trimming line
will not advance after tapping the bump head
on the ground while the trimmer is running,
the cuing line may have tangled or have
disappeared within the cartridge or the cuing
line may have been used up.
NOTE: Excessive Force or Bashing the Trimmer
Bump Head on the ground to advance the cuing
line will damage the bump head.
WARNING: The cuing head continues to rotate
after motor is switched o for a few seconds.
The product is intended for cuing long grass,
pulpy weed, brush and similar vegetation at or
about ground level.
The product is not allowed to be used for cuing
or chopping hedges, shrubs, bushes, flowers and
compost.
FOR BRUSH CUTTER:
WARNING: Always turn o the machine and
make sure the cuing aachment has stopped
before puing a brush cuer down. When
transporting your brush cuer in a vehicle,
properly secure it to prevent turnover, and
damage to the brush cuer. Keep metal cuing
tools covered with the transport guard (optional
accessory).
WARNING: Adjust carrying harness and hand grip
to suit your size before starting work. The machine
should be properly balanced as specied in
your owner’s manual for proper control and less
fatique in operation.
WARNING: Always check your brush cuer for
proper condition and operation before starting,
particularly the switch trigger, safety lock buon,
cuing blade, safety guard.
WARNING: The switch trigger must move freely
and always spring back to the idle position. The
cuing tool must be properly tightened and in
safe operating condition. Inspect for loose parts
(nuts, screws, etc.) and for cracked, bent, warped
or damaged blades.
FOR HEDGE TRIMMER:
ADHUSTING THE TRIMMER HEAD