Log On a Handset
Before you log on to the handset, ensure it has been switched on. See the Mitel 5624 Wireless
Handset Configuration Guide for more information.
1. When the "Login?" window appears, press "Yes".
2. Enter the Call ID.
3. If required, enter the password.
4. Navigate by using Up and Down on the Navigation key.
5. Press “Log in”.
If the handset does not find the WLAN upon start-up, a “No system” dialog window is shown
together with a beep tone and/or vibrator, if enabled. When the dialog window is acknowledged,
a “No Network” screen is shown. If the handset does not receive an IP address from the system,
a “No Access” screen is shown.
Log Off a Handset
Note: The handset must be in idle mode. While in a menu, press the End key to return to idle
mode.
1. Press and hold .
2. When the "Log off?" window appears, press "Yes".
Turn On/Off the Audible Signal
The handset must be in idle mode. A long press on the or in idle mode toggles
the ring signal on/off.
The icon in the status bar indicates a silenced handset.
Lock/Unlock the Keypad
Lock/Unlock the Keypad in Idle Mode
You can lock keys to prevent you from accidentally pressing them.
Lock Keypad
1. Press .
2. Press "Lock".
To Next Page
Loading...
