Operation and Maintenance
28
Applications Card CPU2-S
syd-0620/1.1 – R4.0 – 01.2016
Reset applications card to factory settings
You can reset the applications card to the factory settings. This is recom-
mended if you wish to use the applications card on another communica-
tion server with a different configuration, for example.
Reset the applications card with WebAdmin (recommendation)
To restore the applications card to the factory settings with WebAdmin pro-
ceed as follows:
Warning:
When resetting the applications card, all data saved on the card is
lost.
1. If required create a backup of your current configuration data according to
the indications in "Saving the configuration (menu Maintenance)", page 19
.
2. Navigate to the Multimedia / Maintenance view and click on the First start
button .
You will be asked to enter the applications card password.
3. Enter the current paasword and click the OK button.
The applications card will be reset to the delivery state and rebootet. This
takes a while.
4. In WebAdmin navigate to the Multimedia view and set up the applications
card again according to the instructions under "Configuring the applications
card", page 17.
Reset the applications card locally
As an alternative, you can reset the applications card locally. An image of the
factory installation is located on a hidden partition. You can use this image to
re-establish the delivery state.
To restore the applications card to the factory settings proceed as follows:
Warning:
When resetting the applications card, all data saved on the card is
lost.
1. If required create a backup of your current configuration data according to
the indications in "Saving the configuration (menu Maintenance)", page 19
.
To Next Page
Loading...
Need help?
General
