Setting up Mitel Express Manager
17
3. Access a DOS prompt.
Navigate to the directory that contains the Express Messenger application by
typing
CD EXPRESS [Enter]
4. To start Express Manager, type
EXPRESS [Enter]
The Express Manager Login screen appears after several seconds.
5. Select Login from the File menu and enter the Administrator passcode
(default [1234]).
6. Program Express Messenger as described in this manual.
7. After you have completed your programming session, remove the cable
and replace the PBX front door.
Connecting your PC Remotely
Figure 1 illustrates the proper connection for remote access to Express Messenger.
A serial port on your remote PC connects through a modem to the voice mail
system.
To connect a PC remotely
1. Connect a PC directly to the Express Messenger card and login to
Express Manager application (see Connecting Your PC Directly to the
Express Messenger Card on page 16 for instructions).
2. Select the Options menu, then Communications, and then complete the
Serial Port Setup window according to the requirements of the remotely
located PC port that is connected to your modem. Refer to
Communications on page 125 for instructions on how to complete this
window.
3. Disconnect the local PC from the Express Manager card and replace the
PBX front door.
4. Connect your remotely located PC to a modem.
5. Access a DOS prompt.
6. Navigate to the directory that contains the Express Manager application
by typing
CD EXPRESS [Enter]
7. To start Express Manager, type
EXPRESS [Enter]
8. Select Login from the File menu.
9. Enter the Administrator passcode ([1234] unless changed during
installation) and the telephone number of the voice mail system (auto
attendant) in the initial login window.
To Next Page
Loading...
Need help?
General
