To clean the TA7104/7108, wipe with a soft dry cloth. Do not use volatile liquids such as gas and
thinner that are harmful to the unit casing.
For resistant markings, wet a cloth with a mild detergent, wring well and then wipe off. Use a dry cloth
to dry the surface.
3.6 HARDWARE INSTALLATION
This section describes how to set the connectors of the TA7104/7108.
Warning: Do not connect the TA7104/7108 directly to Telecommunication Systems.
Caution: The TA7104/7108 must be installed on a circuit equipped with a breaker so that you can
easily power the unit off if required.
See Appendix B - Cabling Considerations, for more details on the cables the TA7104/7108 uses.
Connecting Cables
The following describes how to connect the various cables to the TA7104/7108.
Figure 5: TA7104 Hardware Installation
1. Before you begin, be sure that the TA7104/7108 is powered off.
2. Connect analog telephones or fax machines into the Pohne-Fax 1 and Phone-Fax 2 connectors.
Use a standard telecommunication cord with a minimum of 26 AWG wire size.
Note: The TA7104/7108 telephone line interface has been designed to interface with a conventional
telephone or fax machine. Connections to FXS ports of third party devices such as a PBX / Key
System could damage the TA7104/7108.
Connect a 10/100 BaseT Ethernet RJ-45 cable into the WAN connector of the TA7104/7108; connect
the other end to a compatible Ethernet interface that supplies TCP/IP network access (e.g., router,
switch, hub or computer). Use a standard telecommunication cord with a minimum of 26 AWG wire
size. You can either use a crossover or straight Ethernet cable because it performs automatic MDI /
MDIX detection. See “RJ-45 Cable” for more details.
Connect a 10/100 BaseT Ethernet RJ-45 cable into the LAN connector of the TA7104/7108 and
connect the other end to the network card of a computer. Use a standard telecommunication cord with
a minimum of 26 AWG wire size. You can either use a crossover or straight Ethernet cable because it
performs automatic MDI / MDIX detection. See RJ-45 Cable for more details.
Connect the power cord to the TA7104/7108. Do not yet connect the other end of the power
cord to an electrical outlet. You are now ready to start the TA7104/7108.
To Next Page
Loading...
Need help?
General
