Mitel TA7108 - Page 8

TA7104 /7108 Hardware Installation
155/1531-ANF 90114 C 2017-03-08
5
2.
Reset / Default switch
Resets configuration parameters of the TA7104/7108 to default
(known) values. It can be used to reconfigure the unit.
Warning: Read Section “RESET/DEFAULT Button” on page 18 before
attempting to reset the unit.
3.
USB connector
TBD
4.
ETH1
A 10/100 BaseT Ethernet RJ-45 connector for access to a LAN, WAN
or computer. This port is by default used for uplink / WAN connection.
5.
ETH2
A 10/100 BaseT Ethernet RJ-45 connector for access to a LAN, WAN
or computer. This port is by default used for LAN connection.
7.
FXS Port 1 - 4
4 x RJ-11 connectors to attach a conventional telephone or G3 fax machine.