MITOPRO+ XL SERIES
To operate your new MitoPRO+
XL device.
Carefully unbox MitoPRO+ XL device.
Plug in device and turn the power switch on
(orange switch).
Hit the ‘Mode’ button to program the session
A = Red Light only
I = Near Infrared Light only
A I = Red and Near Infrared Light
Press the ‘Time’ button to select the desired
session time.
When powered on the timer defaults to 10 minutes.
When pressing the ‘time’ button the timer will count
up to 20 minutes then start over at 1 minute.
To start your session
Hit the ‘OK’ and the timer will automatically start
counting down until the session ends.
www.mitoredlight.com 23
To Next Page
Loading...