13
• Set the ignition switch Fig 18 to the RUN ( I ) position.
Fig 18
Fig 18
• Slowly pull the recoil starter handle until engagement of the paw with the flywheel is felt.
• While holding the unit, pull out the starter rope firmly until engine fires (indicated by a ‘cough’
from the engine).
• Move the choke lever to the open position Fig 17.
• Pull the starter rope until the engine starts.
• Allow the engine to warm up before use. When cutting, always use the brush cutter on full throttle.
HOT ENGINE STARTING
• Set the ignition switch Fig 18 to the RUN ( I ) position.
• Pull the starter rope until the engine starts.
• If the engine does not start after 5 pulls, use the cold start procedure.
OVERCHOKING
• Should the engine become flooded due to over-choking set the ignition switch to the STOP (O) position
Fig 18, unscrew the spark plug, wipe it dry or replace, pull the recoil starter several times without the
spark plug in place and with choke in the open position. This will help clean and ventilate the
combustion chamber.
STOPPING THE ENGINE
• Set the engine to idling by releasing the throttle lever.
• Set the ignition switch to the STOP (O) position Fig 18.
• If the engine fails to stop, set the choke lever to the closed position to stall the engine; do not use the
machine until the ignition switch is repaired.
RUNNING IN
Fig 16
Fig 17
To Next Page
Loading...
