Chapter 24 Backup/Restore 201
Restore Configuration
Restore Configuration allows you to upload a new or pr
eviously saved configuration file from your
computer to your Device.
Table 84 Restore Configuration
LABEL DESCRIPTION
File Path Type in the location of the file you want to upload in
this field or click Browse ... to find
it.
Browse... Click this to find the file you want to upload. Remember that you must decompress
compressed (.ZIP) files before you can upload them.
Upload Click this to begin the upload process.
Reset Click this to reset your device settings back
to the factory default.
Do not turn off the Device while configuration file upload is in progress.
After the Device configuration has been restored successfully, the login screen appears. Login again
to restart the Device.
The Device automatically restarts in this time ca
using a temporary network disconnect. In some
operating systems, you may see the following icon on your desktop.
Figure 133 N
etwork Temporarily Disconnected
If you restore the default configuration, you may need to change the IP address of your computer to
be in the same subnet as that of the default device IP address (192.168.1.1).
If the upload was not successful, an error screen will appear. Click OK
to go back to the
Configuration screen.
To Next Page
Loading...
General