Connection of MELSEC-QnA Series PLC 10
10-1
1
Introduction
2
Outline
3
Specifications
4
installation
and Wiring of
F940GOT
5
installation
and Wiring of
Handy GOT
6
Connection of
Peripheral
Equipment
7
Connection of
Two or More
GOT Units
8
Connection of
MELSEC-F FX
Series PLC
9
Connection of
MELSEC-A
Series PLC
10
Connection of
MELSEC-QnA
Series PLC
10. Connection of MELSEC-QnA Series PLC
This chapter explains connection of the GOT-F900 Series display unit to the QnA Series PLC.
Connection Procedure
This section introduces the procedure to connect the GOT-F900 to the QnA Series PLC.
1.
Preparation
2.
Setting
3.
Others
Item name Description Reference
System Condition
You can learn the connection availability as well as the version of the
GOT-F900 OS and the screen creation software.
10.1
System Configuration
You can select the configuration between the GOT and the QnA Series
PLC/computer link unit as well as proper cables.
10.2
Item name Description Reference
QnACPU Selection in
Direct Connection
In the QnA computer link, the following setting is required.
When QnA connection is selected, the GOT-F900 is automatically set to
fixed values. No setting is required in the QnA Series PLC.
−
Setting in QnA Computer
Link Connection
You can learn the communication specifications and the setting. 10.3
Caution on Use of
MELSEC-QnA Series
PLC
You can learn the restrictions in connecting the GOT to the QnA Series
PLC.
10.4
Setting of Connected
Equipment for GOT
Set the PLC type using the GOT or the screen creation software. 10.5
Item name Description Reference
Cable Diagram Cable diagrams for QnA Series PLC/GOT connection 10.6
Troubleshooting Description of errors and how to fix them 10.7
Setting of QnA
computer link
The contents of setting of computer link 10.3.1
Setting
examples
Switch setting in each computer link 10.3.2
GOT-F900 SERIES (CONNECTION)
To Next Page