Mitsubishi Electric FX3U SERIES - Page 933

931
FX3G/FX3U/FX3UC Series Programmable Controllers
Programming Manual - Basic & Applied Instruction Edition
B Instruction Execution Time
B-6 Execution Time on Combination of Applicable Devices and Indexing
31
FNC276-FNC279 Data Transfer 3
32
FNC280-FNC289 High-Speed Processing 2
33
FNC290-FNC299 Extension File Register
34
FNC300-FNC305 FX
3U
-CF-ADP
35
SFC•STL Programming
36
Interrupt Function
37
Special Device
38
Error Code
A
Version Up Information
B
Execution Times
•FX3G PLCs
- Data comparison instruction (16-bit operation)
*1. When K4 is specified, and the head bit device number is a multiple of 8 (K4M0, K4M8 ...)
- Data comparison instruction (32-bit operation)
*1. When K8 is specified, and the head bit device number is a multiple of 8 (K8M0, K8M8 ...)
S (source)
D (destination)
Standard mode Extension mode
Without indexing (μs) With indexing (μs) Without indexing (μs) With indexing (μs)
KnY,
KnM,
KnS
T,C,D,R
KnY,
KnM,
KnS
T,C,D,R
KnY,
KnM,
KnS
T,C,D,R
KnY,
KnM,
KnS
T,C,D,R
KnX,KnY,KnM,KnS
*1
2.12 2.2 11.28 9.18 3 3.12 13.12 10.7
T,C,D,R 2.24 2.36 9.78 7.58 3.16 3.24 11.52 9.32
K,H 1.4 1.52 8.88 6.78 2.12 2.24 10.32 8.12
S (source)
D (destination)
Standard mode Extension mode
Without indexing (μs) With indexing (μs) Without indexing (μs) With indexing (μs)
KnY,
KnM,
KnS
T,C,D,R
KnY,
KnM,
KnS
T,C,D,R
KnY,
KnM,
KnS
T,C,D,R
KnY,
KnM,
KnS
T,C,D,R
KnX,KnY,KnM,KnS
*1
2.52 2.76 11.68 9.68 3.48 3.68 13.32 11.32
T,C,D,R 2.8 3 10.72 8.28 3.72 3.92 11.92 9.92
K,H 1.4 1.76 9.28 7.28 2.36 2.68 11.12 9.12