Mitsubishi Electric MELSEC FX Series - Page 74

Learning to Use the FX Family for Positioning Control Inverter Drive Control
4 - 32
MITSUBISHI ELECTRIC
Function Number Description
Writing
parameters to
the inverter
while the PLC is
in RUN mode.
 The maximum frequency (Pr. 1) is specified
 The maximum frequency (Pr. 1) is set to "120 Hz"
 The minimum frequency (Pr. 2) is specified
 The minimum frequency (Pr. 2) is set to "5 Hz"
 The acceleration time (Pr. 7) is specified
 The acceleration time (Pr. 7) is set to "1 sec"
 The deceleration time (Pr. 8) is specified
 The deceleration time (Pr. 8) is set to "1 sec"

The parameters are written at one time
[Contents of D200–D207  Pr. 1, Pr. 2, Pr. 7 and Pr. 8]
 The maximum frequency (Pr. 1) is set to "120 Hz" [K12000  Pr. 1]
 The minimum frequency (Pr. 2) is set to "5 Hz" [K500  Pr. 2]
 The acceleration time (Pr. 7) is set to "1 sec" [K10  Pr. 7]
 The deceleration time (Pr. 8) is set to "1 sec" [K10  Pr. 8]
 Reset driving of write instruction
Tab. 4-22: Description of the program example in fig. 4-21