What to do if Mitsubishi Electric MELSEC FX Controller shows set value backup error flag?
If the Mitsubishi Electric Controller displays a set value backup error flag, try turning the power off and then on again to see if the issue resolves. This error may be caused by noise or a failure in the 4LC. If the problem persists, it is recommended to consult a Mitsubishi Electric distributor.
What to do if Mitsubishi Electric Controller displays adjustment data error?
If the Mitsubishi Electric Controller shows an adjustment data error, cycle the power off and on to check for any changes. This error may be due to noise or a failure within the 4LC. If the problem continues, reach out to a Mitsubishi Electric distributor for further assistance.
What does it mean when the 24V DC power supply error appears on a Mitsubishi Electric MELSEC FX?
The 24V DC power supply error on your Mitsubishi Electric Controller indicates that the driving power supply (24V DC) is not being supplied.
What to do if Mitsubishi Electric MELSEC FX displays cold contact temperature compensation data error?
If you encounter a cold contact temperature compensation data error on your Mitsubishi Electric Controller, try turning the power off and then on again to see if the state changes. This issue may stem from noise or a failure in the 4LC. If there's no improvement, it's best to consult a Mitsubishi Electric distributor.
General| Manufacturer | Mitsubishi Electric |
|---|---|
| Output Type | Relay, Transistor, Triac (depending on model) |
| Programming Software | GX Works2, GX Developer |
| Type | Programmable Logic Controller (PLC) |
| I/O Capacity | Up to 256 I/O points |
| Programming Languages | Ladder Diagram (LD), Instruction List (IL), Function Block Diagram (FBD) |
| Communication Ports | RS-422, RS-485, Ethernet (depending on model) |
| Power Supply | 100-240V AC or 24V DC (depending on model) |
| Expansion Modules | Digital I/O, Analog I/O, Communication, Special Function |
| Program Memory | Up to 32K steps (depending on model) |
| Data Memory | Varies by model |
| Operating Temperature | 0°C to 55°C |
| Humidity | 5 to 95% RH, non-condensing |
| Vibration Resistance | 10 to 57 Hz: Amplitude 0.075 mm, 57 to 150 Hz: 9.8 m/s2 |
To Next Page
