Mitsubishi Electric MELSEC FX Series - 7.8.10 TO

7 Applied Instructions
7.8 External FX I/O Device
399
FXCPU Structured Programming Manual
(Basic & Applied Instruction)
1
Outline
2
Instruction List
3
Configuration of Instruction
4
How to Read Explanation of Instructions
5
Basic Instruction
6
Step Ladder Instructions
7
Applied Instructions
8
Interrupt Function and Pulse Catch Function
A
Relationships between devices and addresses
7.8.10 TO
Outline
This instruction writes data from PLC into the buffer memory (BFM) of special extension unit/block.
By this instruction, when data is written into multiple buffer memories (BFM) in batch a watchdog timer error
may occur. When there is no bad influence for the control if the data is divided and written in, you can use
WBFM instruction.
1. Format and operation, execution form
2. Set data
*1. In the case of FXU, FX1N, FX2N, FX2C, FX1NC, FX2NC series, the data type of DTO, DTOP of 32-bit
operation is ANY16.
FX3U(C) FX3G FX2N(C) FX1N(C) FX1S FXU/FX2C FX0N FX0(S)
Instruction
name
Operation
Execution
form
Expression in each language
Structured ladder ST
TO 16 bits Continuous TO(EN, s, n1, n2, n3);
TOP 16 bits Pulse TOP(EN, s, n1, n2, n3);
DTO 32 bits Continuous DTO(EN, s, n1, n2, n3);
DTOP 32 bits Pulse DTOP(EN, s, n1, n2, n3);
Variable Description
Data type
16-bit
operation
32-bit
operation
Input
variable
EN Execution condition Bit
Transfer source data or device
• 16-bit operation: n3 points occupied
• 32-bit operation: 2 × n3 points occupied
ANY16 ANY32
Unit No. of special extension unit/block
(Sequentially from the right side of basic unit, K0 to K7)
ANY16
ANY32
*1
Transfer destination buffer memory (BFM) number ANY16
ANY32
*1
Number of transfer points ANY16
ANY32
*1
Output
variable
ENO Execution state Bit
TO
EN
s
ENO
n1
n2
n3
TOP
EN
s
ENO
n1
n2
n3
DTO
EN
s
ENO
n1
n2
n3
DTOP
EN
s
ENO
n1
n2
n3