Learning to Use the FX Family for Positioning Control Inverter Drive Control
4 - 34
MITSUBISHI ELECTRIC
Function Number Description
Setting the oper-
ation speed of
the inverter to
40 Hz while the
PLC is in RUN
mode.
The write instruction is driven
The operation speed is set as "40 Hz"
The preset frequency is written to the inverter [Contents of D10 "H0ED"]
Reset driving of write instruction
Controlling the
inverter to move
in the forward or
reverse rotation
direction.
Operation stop "H0FA" is set to "00H"
Operation is driven by input X002 or X003
Forward rotation command b1 of "H0FA" is set to ON
Reverse rotation command b2 of "H0FA" is set to ON
Changes in the operation commands (M20 to M27) are detected
Tab. 4-23:
Description of the program example in fig. 4-22
To Next Page
Loading...
