Mitsubishi Electric MELSEC iQ-F Series - Page 101

APPX
Appendix 1 Instruction Replacement List
99
A
Precautions
Even if the instructions are supported by GX Works3, a conversion error may occur due to the difference of the setting range
of FX3S/FX3G/FX3U/FX3UC.
Instructions/FB/FUN that are not supported by the FBD/LD program will be undefined instructions/FB/FUN.
WR3AP  WR3AP Correct the program to use TOP
instruction.
COMRD  COMRD 
COMRDP  COMRDP 
DHSCT  DHSCT Set the high-speed comparison table
or multi-point output high-speed
comparison table in the module
parameter “High-speed I/O”.
SAVER  SAVER Correct the program to use
ERWRITE instruction.
INITR  INITR Correct the program to use FMOV
instruction. Correct the program to
collectively initialize (clear to 0) the
required number of points of the file
register (R).
INITRP  INITRP Correct the program to use FMOVP
instruction. Correct the program to
collectively initialize (clear to 0) the
required number of points of the file
register (R).
LOGR  LOGR Use the data logging function.
Save the collected data to the SD
memory card as a CSV or binary file.
* The data cannot be stored in the file
register (R) or the extension file
register (ER) in the SD memory card.
LOGRP  LOGRP
FLCRT  FLCRT 
FLDEL  FLDEL 
FLWR  FLWR 
FLRD  FLRD 
FLCMD  FLCMD 
FLSTRD  FLSTRD 
GET_BIT_OF_INT  GET_BIT_OF_INT 
GET_BIT_OF_INT_E  GET_BIT_OF_INT_E 
SET_BIT_OF_INT  SET_BIT_OF_INT 
SET_BIT_OF_INT_E  SET_BIT_OF_INT_E 
CPY_BIT_OF_INT  CPY_BIT_OF_INT 
CPY_BIT_OF_INT_E  CPY_BIT_OF_INT_E 
FX3 Series  MELSEC iQ-F Remarks