Mitsubishi Electric MELSEC iQ-F Series - Page 104

102
APPX
Appendix 1 Instruction Replacement List
TKY  TKY Create the program using the input
device (X).
DTKY  DTKY
HKY  HKY
DHKY  DHKY
ARWS  ARWS
ASC  ASC 
PR  PR 
RS  RS Correct the program to use RS2
instruction.
VRRD  VRRD 
VRRDP  VRRDP 
VRSC  VRSC 
VRSCP  VRSCP 
INT  INT Correct the program to use FLT2INT
instruction.
INTP  INTP Correct the program to use
FLT2INTP instruction.
DINT  DINT Correct the program to use
FLT2DINT instruction.
DINTP  DINTP Correct the program to use
FLT2DINTP instruction.
DTBL  DTBL Correct the program to use TBL
instruction.
ZRN  ZRN Correct the program to use DSZR
instruction. Use the same device for
near-point dog signal and zero point
signal of the DSZR instruction, and
set the zero point signal count start
time to the rear end and the zero
point signal count to 1.
DZRN  DZRN Correct the program to use DDSZR
instruction. Use the same device for
near-point dog signal and zero point
signal of the DDSZR instruction, and
set the zero point signal count start
time to the rear end and the zero
point signal count to 1.
RD3A  RD3A Correct the program to use FROM
instruction.
RD3AP  RD3AP Correct the program to use FROMP
instruction.
WR3A  WR3A Correct the program to use TO
instruction.
WR3AP  WR3AP Correct the program to use TOP
instruction.
COMRD  COMRD 
COMRDP  COMRDP 
DHSCT  D
HSCT Set the high-speed comparison table
or multi-point output high-speed
comparison table in the module
parameter “High-speed I/O”.
SAVER  SAVER Correct the program to use
ERWRITE instruction.
INITR  INITR Correct the program to use FMOV
instruction. Correct the program to
collectively initialize (clear to 0) the
required number of points of the file
register (R).
FX3 Series  MELSEC iQ-F Remarks