6 Replacement from FX3UC to FX5UC
6.4 Conversion of the Projects
87
6
• For GX Works3 versions earlier than 1.025B, the program must be changed from “No Execution Type”. (Change to Scan,
etc.)
• When projects are converted, the program instructions and devices may be changed. Check the contents of the project.
Parameters other than the network parameter of CC-Link
*1
will be deleted. Set the parameters if necessary.
*1 For the network parameter of CC-Link, refer to Page 87 Precautions when Replacing the Parameters.
6. Set the model name of the CPU for the system parameter.
[System Parameter] [I/O Assignment Setting] Model Name
7. Perform conversion.
[Convert] [Rebuild All]
Precautions when Converting the Projects
• When converting FX3UC projects using GX Works3, be careful because the program (instructions and devices) may be
changed.
• When converting projects, the number of steps may increase and writing to the FX5UC may be impossible. Check the
number of steps after replacement.
• Characters used for the label name in GX Works2 may correspond to reserved words or illegal characters in GX Works3. In
that case, change the label name.
For precautions regarding instruction and device conversion, refer to Page 92 Instruction Replacement List.
Precautions when Replacing the Parameters
When converting FX3UC projects to FX5UC projects, the setting data of the parameters (PC parameters and network
parameters) and special modules (intelligent function modules) will be deleted. Therefore, it is necessary to set the data with
GX Works3 again.
Also, GX Works3 does not support the following parameters of the FX3UC, so it is necessary to set these parameters with GX
Works3 again.
• Network parameter (CC-Link)
• Intelligent function module parameter (AnyWireASLINK)
Set the model name of the CPU.
To Next Page
Loading...
