22
4.3 Basic Functions Setting
4.3.1 Remote Controller Main/Sub Setting
When using two remote controllers, they must be designated as the main and sub remote controllers.
The following settings can be made.
1 MAIN (default) : The remote controller is set as the main controller.
2 SUB : The remote controller is set as the sub controller.
To Change the Main/Sub Setting
■ Display example
(1) While pressing the
button, press the
button for two seconds to activate the remote controller’s function
selection mode.
(2) Press the
button until
appears on the screen (at A).
[Display A]
(3) Press the
button to select “CONTROLLER” on the screen (at A).
(4) Press the
button to select “CONTROLLER MAIN” or “CONTROLLER SUB” on the screen (at A).
[Display A]
(5) While pressing the
button, press the
button for two seconds to return to normal mode.
CHANGE
LANGUAGE
FUNCTION
SELECTION
MODE
SELECTION
DISP MODE
SETTING
CONTROLLER
MAIN
CONTROLLER
SUB