To Next PageTo Next PageWhy does my Mitsubishi Electric PEAD-30 make cracking noises?
The cracking or creaking sound you hear from your Mitsubishi Electric Air Conditioner can be heard when parts rub against each due to expansion and contraction from temperature changes.
What to do if an error code appears on my Mitsubishi Electric Air Conditioner remote?
If an error code appears on the remote controller display of your Mitsubishi Electric Air Conditioner, the protection devices have operated to protect the air conditioner. Turn off the power switch immediately and consult your dealer. Be sure to provide the dealer with the model name and information that appeared in the remote controller display. Do not attempt to repair this equipment by yourself.
Why is my Mitsubishi Electric PEAD-30 Air Conditioner remote not working?
If nothing appears on your Mitsubishi Electric IR wireless remote controller display, the display is faint, or signals aren't received unless very close, the batteries are likely low. Replace the batteries and press the Reset button. If nothing appears even after replacing the batteries, make sure that the batteries are installed in the correct directions (+, –).
Why doesn't my Mitsubishi Electric PEAD-30 blow warm air immediately when heating starts?
Warm air does not blow from the indoor unit of your Mitsubishi Electric Air Conditioner until it has sufficiently warmed up.
Why does my Mitsubishi Electric Air Conditioner stop heating before reaching the set temperature?
During heating mode, if your Mitsubishi Electric Air Conditioner stops before reaching the set room temperature, it may be because when the outdoor temperature is low and the humidity is high, frost may form on the outdoor unit. Normal operation should begin after approximately 10 minutes.
Why won't my Mitsubishi Electric Air Conditioner turn back on immediately?
If your Mitsubishi Electric Air Conditioner doesn't restart immediately after stopping, wait approximately three minutes. Operation has stopped to protect the air conditioner.
Why does my Mitsubishi Electric PEAD-30 Air Conditioner make a draining noise?
The draining water or motor rotation sound you hear from your Mitsubishi Electric Air Conditioner is the drain pump operating and then stopping when cooling operation stops. Wait approximately 3 minutes.
Why does the fan speed of my Mitsubishi Electric PEAD-30 change automatically?
The fan speed of your Mitsubishi Electric Air Conditioner changes automatically for the following reasons: * To avoid blowing out cold air at the beginning of heating operation, the air conditioner automatically adjusts the fan speed gradually from lower to the set speed. * It also adjusts its fan speed to protect the fan motor when return air temperature or fan speed excessively rises.
What does it mean when the operation lamp is blinking on my Mitsubishi Electric PEAD-30?
If the operation lamp near the receiver for the IR wireless remote controller on the indoor unit of your Mitsubishi Electric Air Conditioner is blinking, the self diagnosis function has operated to protect the air conditioner. Turn off the power switch immediately and consult your dealer. Be sure to provide the dealer with the model name. Do not attempt to repair this equipment by yourself.
Why does my Mitsubishi Electric Air Conditioner make a hissing sound?
The flowing water sound or occasional hissing sound you hear from your Mitsubishi Electric Air Conditioner can be heard when refrigerant is flowing in the air conditioner or when the refrigerant flow is changing.
General| Brand | Mitsubishi Electric |
|---|---|
| Model | PEAD-30 |
| Category | Air Conditioner |
| Language | English |
