5 - 87
MELSEC-A
5 DATA USED FOR POSITIONING CONTROL
Pr.127
Monitor output 1 offset
Set the offset voltage for the monitor output 1.
Pr.128
Monitor output 2 offset
Set the offset voltage for the monitor output 2.
Pr.130
Zero speed
Set the servomotor speed at which the motor speed is judged as zero.
Pr.131
Error excessive alarm level
Set the range in which a droop pulse excess alarm will be output.
Pr.132
Option function 5
Select the PI-PID control switching.
Pr.134
PI-PID switching position droop
Set the position droop amount at which PI control is switched to PID control during
position control.
Pr.136
Speed differential compensation
Set the differential compensation value of the actual speed loop.
To Next Page
Loading...
