6 - 10
MELSEC-A
6 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL
Continued from previous page
No.9
Positioning start No.
setting program
No.12
JOG operation program
No.13
Manual pulse generator
operation program
No.10
Positioning start signal input program
No.11
Reset program
* Program required to carry out
• "Zero point return control"
• "Main positioning control"
• "Advance
d positioning control"
* Program required to carry out
"manual control"
Refer to section 6.5.2
Refer to section 6.5.3
Refer to section 11.2.4
Refer to section 11.3.4
Program to reset the start
signal and turn the M code
ON signal OFF
Start details setting program
Start program
JOG operation program
Manual pulse generator
operation program
Continued on next page
To Next Page
Loading...
