Mitsubishi A1SD75M3

10 - 5
MELSEC-A
10 ADVANCED POSITIONING CONTROL
Set in AD75 the "start block data" and "condition data" corresponding to the following
"block Nos. 7001 to 7010" using the AD75 software package. (The following drawing
shows an example for axis 1.)
7001
7010
* Setting is only possible when the AD75 software package is used.
(Same for axis 2 and axis 3.)
Open
50th point
Setting item
2nd point
Setting item
No.10
Setting item
Condition identifier
No.2
Setting item
1st point
Setting item
Axisi 1 start block data
b15
b0b7
b8
b15 b0
b7b8
No.1
Setting item
Da16 Address
Open
Open
Da17 Parameter1
Da18 Parameter2
b15 b0b7b8b11b12
Condition identifier
Da12 Special start
command
Da13 Parameter
Da10 Shape
Da11 Start positioning data No.
Axisi 1 start condition data
Da14 Condition target
Da15 Condition
operater
50th point
Setting item
2nd point
Setting item
No.10
Setting item
Condition identifier
No.2
Setting item
1st point
Setting item
Axisi 1 start block data
b15
b0b7b8
b15 b0
b7b8
No.1
Setting item
Da16 Address
Open
Da17 Parameter1
Da18 Parameter2
b15 b0b7b8b11b12
Condition identifier
Da15 Condition
operater
Da14 Condition target
Da12 Special start
command
Da13 Parameter
Da10 Shape
Da11 Start positioning data No.
Axisi 1 start condition data