Mitsubishi A1SD75M3

3 - 11
MELSEC-A
3 SPECIFICATIONS AND FUNCTIONS
Functions that
compensate
control
Functions that limit
control
Functions that change
control details
Other functions
Backlash compensation function Electronic gear function Near pass mode function Speed limit function Torque limit function Software stroke limit function Hardware stroke limit function Speed change function Override function Acceleration/ decelerat- ion time change function Torque change function Step function Skip function M code output function Teaching function Command in-position function Acceleration/decelera- tion process function Indirectly specification function
– – – – – – – – – – – – – – – –
*
2
– – – – – – – – – – – – – – – –
–
–
REMARK
•
The "common functions" are functions executed as necessary. (These are not combined
with the control.)
•
"Advanced positioning control" is a control used in combination with the "main positioning
control". For combinations with the auxiliary functions, refer to the combinations of the "main
positioning control" and auxiliary functions.