1-29
Error no. L2530
1Error list
L2530 Error message There is no area where data is written.
Cause There is no area where data is written.
Measures Please read the data by using TrRd
L2540 Error message There is no read data.
Cause There is no read data.
Measures Please use TrRd after executing TrWrt.
L2560 Error message Ilegal parameter of Tracking.
Cause The value of the parameter: EXTENC is outside the range. setting range: 1-8.
Measures Please check the value of parameter.
L2580 Error message No workpiece in the tracking area.
Cause There is no workpiece in the tracking buffer or “TrkMv On” command is executed.
Before the workpiece enters to the tracking area.
Measures Execute “TrkMv On” command when the workpiece is in the tracking area.
L2601 Error message Start pos. exseeds the limit
Cause The start position is outside the operation range.
Measures Adjust the position.
L2602 Error message DSTN pos. exseeds the limit
Cause The target position is outside the operation range.
Measures Adjust the position.
L2603 Error message Med pos. data exseeds the limit
Cause The intermediate position is outside the operation range.
Measures Adjust the position.
L2610 Error message Spline interpolation error (Spline file)
Cause An error related to the spline file occurred.
Measures Refer to the error details No. and check the details of the occurring error. Then take actions for those
error details.
Error message Can't open spline file
Cause The spline file corresponding to the spline No. designated with the MvSpl command could not be opened.
Measures Check that the spline No. designation is correct, and that the target spline file is saved in the controller.
Error message Spline file is broken
Cause The spline file contents did not match the checksum.
Measures Open the target spline file and check the contents. Then, save the file again to recreate the spline file.
Write the new file to the controller again.
Error message Spline file is not supported.
Cause The designated spline file cannot be used with the current controller.
Measures Check the spline file and controller versions. It may be necessary to upgrade the software version.
Error message Can't change spline file.
Cause The target spline file is currently being used for spline interpolation (file is open).
Measures A spline file currently being used for spline interpolation (file is open) cannot be exported to the controller,
deleted or renamed. Carry these out after spline interpolation ends.
Error message Can't get data.
Cause The spline file is closed so the data cannot be retrieved.
Measures Reset the program, and then execute the MvSpl command again.
Error message The setting of Ex-T is illegal
Cause The setting of Ex-T is illegal
Measures Please confirm the number and the content of the file
Error message Cannot make the spline file
Cause The specified spline file is opened already
Measures Please confirm the specified number
Error No. Error cause and measures
To Next Page
Loading...
