Appendix-77
6
The position becomes offset during automatic drive.
The position becomes offset after moving the equipment.
Cause
・ Program error (arithmetic processing, etc.).
・ Teaching operation error.
・ Peripheral equipment is offset.
・ There is a setting error in the origin position data.
・ The origin position data has been lost (battery life, etc.).
・ Origin positions are offset (the arm was moved while the power supply was OFF, etc.)
・ Connecting parts have come loose.
・ Belt teeth have been skipped.
・ Increased backlash from the reduction gear.
Measures
・ Check the positioning data in the area where the positioning has become offset.
・ Check the peripheral equipment and the robot’s connecting parts (hand, robot installation section, etc.)
・ Check the remaining time on the robot battery’s life.
・ Check the position of the origin positions.
・ Check the condition of the belt.
・ Check whether there is any nearby interference, etc.
If no improvement is made after carrying out the above measures, please contact the manufacturer.
7
The leakage current breaker trips when the controller’s primary power switch is turned ON.
The leakage current breaker trips when the servo is switched on.
Cause
・ Incorrect breaker selection (current capacity/drive purpose, etc.).
・ Leakage current due to electrically conductive foreign matters (oil/moisture) getting inside.
・ Earthing due to cable wear.
Measures
・ Check the specification of the breaker.
・ Check whether or not electrically conductive foreign matters have got inside the robot’s body or inside the
controller.
・ Check whether or not the cable is damaged.
8
Oil is leaking from the robot’s body
Cause
・ Deterioration in the reducer oil seal.
・ Too much grease was applied.
・ A grease other than the specified grease was applied.
・ Excess grease left on the unit when grease was applied.
・ Foreign materials have stuck to the oil seal (dust, etc.).
Measures
・ Check the amount of grease that should be applied and the name and product number of the grease.
・ Take measures to make sure that dust, etc. does not adhere to joints.
・ After applying grease wipe off any grease that is protruding.
9
Breaker trips/overcurrent error occurs
(cutting oil gets inside the robot body)
Cause
・ Deterioration in the packing.
・ Scaling on the packing.
・ Using a highly permeable cutting oil.
・ An environment that exceeds the IP functionality.
Measures
・ In a mist environment, pull off and replace the packing every time the cover is removed.
・If a highly permeable cutting fluid is being used, or in an environment that exceeds the IP functionality, purge the air
and take measures on the jacket.
* Cutting oil that has got inside the arm must be thoroughly cleaned away or the components inside the arm are at
risk of rotting.
No. Issue
To Next Page
Loading...
Need help?
General
